Filament Comparison Table

Compare the performance of 3D printer filaments at a glance. Check printing temperature, warping, strength, creep resistance, and heat resistance with star ratings and numerical values.

Select Filaments to Compare

Selected Filaments:

PLA

PETG

Add Filaments:

Filament	Print Temp	Warping	Strength	Flex. Modulus	Creep Resistance	Heat Resistance	Remove
PLA	Nozzle: 190-220°C Bed: 50-60°C	Low warping; beginner-friendly	77.05 MPa	2879 MPa	Not ideal for sustained loads	Heat resistance temp: 55°C
PETG	Nozzle: 220-250°C Bed: 70-80°C	Moderate warping	76.69 MPa	2033 MPa		Heat resistance temp: 75°C

Click column headers to sort. Click "Filament" to restore original order.

Material	Temp	Warping	Strength	Flex. Modulus	Creep Resistance	Heat Resistance	Remove
PLA	N:190-220°C B:50-60°C	Low warping; beginner-friendly	77.05 MPa	2879 MPa	Not ideal for sustained loads	Heat resistance temp: 55°C
PETG	N:220-250°C B:70-80°C	Moderate warping	76.69 MPa	2033 MPa		Heat resistance temp: 75°C

Tap column headers to sort. Tap "Material" to restore.

Rating Criteria

Print Temperature: Lower temperature = higher rating (★5=low temp, ★1=high temp)

Warping: Less warping = higher rating (★5=minimal warping, ★1=high warping)

Strength: Higher bend strength = higher rating (★5=very strong, ★1=weak)

Creep Resistance: Better long-term load resistance = higher rating (★5=high resistance, ★1=low resistance)

Heat Resistance: Higher temperature tolerance = higher rating (★5=very high, ★1=low)

Not entered: ☆☆☆☆☆ + "Not entered" or "Not measured" displayed

Stress–Strain Curve

Compare bending test results of selected filaments with stress–strain curves. Horizontal axis shows strain (%), vertical axis shows stress (MPa). Each filament displays data from the highest priority manufacturer.

Measurement Direction:

No bending test data (Pattern 1) available for selected filaments. Graphs will be displayed when data is added.

Download Raw Data

The raw CSV data used in the graphs above is available for download.

Download Raw Data

Data Usage

Personal use is free, but if you wish to publish in videos, articles, SNS, or redistribute data, please contact us in advance. See Data Usage Policy for details.

Notes

Ratings indicate general trends and may vary by manufacturer and grade.
Stress–strain curves are calculated from 3-point bending test results.
Results may vary depending on test conditions (span, specimen dimensions, speed, etc.).
"Not entered" and "Not measured" items may be updated with data in the future.
For detailed properties and print settings, please check individual filament pages.

Back to Filament List